Video - Yamaha AVENTAGE RX-A3050 Owner's Manual

Video

Problem
No video.
No video from the playback device (connected to
the unit with HDMI).
The menu of the unit is not displayed on the TV.
The video is interrupted.
Cause
Another input source is selected on the unit.
Another input source is selected on the TV.
The video signal output from the unit is not supported by the TV.
The cable connecting the unit and TV (or playback device) is
defective.
The input video signal (resolution) is not supported by the unit.
The TV does not support HDCP (High-bandwidth Digital Content
Protection).
The playback device that supports HDCP 2.2 is connected to the
VIDEO AUX (HDMI IN) jack.
The number of devices connected to the HDMI OUT jack is over
the limit.
The TV is not connected to the unit via HDMI.
Another input source is selected on the TV.
(If you are using 2 TVs in the main zone)
Another TV is turned off when "HDMI OUT 1+2" is selected.
(If the HDMI OUT 2 jack is assigned to Zone2 or Zone4)
HDMI audio output may be interrupted during some zone
operations due to internal circuitry switching.
En
Remedy
Select an appropriate input source with the input selection keys.
Switch the TV input to display the video from the unit.
Set "MONITOR CHECK" in the "ADVANCED SETUP" menu to "YES" (p.158).
If there is no problem with the connection, replace with another cable.
To check the information about the current video signal (resolution), use "Video
Signal" in the "Information" menu (p.154). For information about video signals
supported by the unit, see "HDMI signal compatibility" (p.184).
Refer to the instruction manuals for the TV and check the TV's specifications.
If you want to play back contents that require HDCP 2.2-compatible devices, both
the TV and playback device must support HDCP 2.2.
To play back contents that require HDCP 2.2-compatible devices, connect the
playback device to the HDMI (AV 1–7) jack (p.42).
Disconnect some of the HDMI devices.
You can display the menu of the unit on the TV only when they are connected with
an HDMI cable. If necessary, use an HDMI cable to connect them (p.39).
Switch the TV input to display the video from the unit (HDMI OUT jack).
Select "HDMI OUT 1" or "HDMI OUT 2" to output the signals only to the TV you
are using (p.72).
For details, see "Connecting an HDMI-compatible device to play back
videos/audio" (p.106).
169