Yanmar 4JH45 Operation Manual page 29

12/05
LCD control
(hour meter, coolant temperature, display brightness, oil pressure, battery voltage)
You can switch (scroll) between displays
by pressing the buttons on the bottom as
the default setting.
• Switching screens by pressing the
right button (Pressing the left button
switches the screens in the opposite
direction.)
Press the power switch.
• After 4 seconds, the LCD shows the
hour meter.
Pressing the right button on the bottom of
the LCD shows the temperature display.
Select between Metric units (°C) and
Imperial units (°F) at the "System Units
screen" on the next page.
Pressing the right button again shows the
LCD brightness settings.
To set the brightness of the backlight:
Press the left button continuously and
the digits of the LCD start flashing.
In this condition, press the right button
to decrease the brightness and the left
button to increase the brightness.
(The brightness changes in 6 steps of 20 %.)
To set the desired brightness, do not
touch the buttons for 3 seconds.
Note: Continuously pressing means
holding the button for approx. 2
seconds.
Next, press the right button to show the
pressure display. Select between Metric
units (BAR) and Imperial units (PSI) at the
"System Units screen" on the next page.
Press again to show the battery voltage.
Pressing the button once more, return the
display to the initial hour meter.
Return to hour meter
JH Series Operation Manual
PRODUCT OVERVIEW
Figure 2
Engine hour ( >300 min
Coolant temperature
Metric
Backlighting Brightness
1
Push and hold
(display will blink when
ready)
Oil pressure
Metric
Battery voltage
Return to hour meter
Figure 11
Scroll
-1 )
Imperial units
2 3
Scroll
100, 80, 60, 40, 20, 0
(value will be set after
3 seconds)
Imperial units
055130-00EN01
23