Maintenance; Care After Wash; Storing The Washer; Cleaning The Dispenser - LG GCW1069CS Owner's Manual

66

MAINTENANCE

MAINTENANCE

Care after wash

After the cycle is finished, wipe the door and the inside of
the door seal to remove any moisture. Leave the door open
to dry the washer tub interior. Wipe the body of the washing
machine with a dry cloth to remove any moisture
WARNING
• Unplug the washer before cleaning to avoid the risk of
electric shock. Failure to follow this warning can cause
serious injury,fire, electrical shock or death.
• Never use harsh chemicals, abrasive cleaners, or sol-
vents to clean the washer. They will damage the finish.
• Do not use volatile substances (benzene, paint thin-
ner, alcohol, acetone, etc.) or detergents with strong
chemical components when cleaning the washing
machine. Doing so may cause discoloration or damage
to the machine, or it may cause a fire.

Storing the Washer

If the washer will not be used for an extended period of
time and is in an area that could be exposed to freezing
temperatures:
1. Turn off water supply tap.
2. Disconnect hoses from water supply and drain water
from hoses.
3. Plug the power cord into a properly grounded electrical
outlet.
4. Add 1 gallon of nontoxic recreational vehicle (RV)
antifreeze to the empty wash drum. Close door.
5. Select the spin cycle and let washer spin for 1 minute to
drain out all the water.
6. Unplug the power cord, dry the drum interior with a soft
cloth, and close the door.
7. Remove the inserts from the dispenser. Drain any water
in compartments and dry the compartments.
8. Store the washer in an upright position.
9. To remove the antifreeze from the washer after storage,
run washer through a complete cycle using detergent.
Do not add laundry!
NOTE
• Not all of the RV antifreeze will be expelled.
• Weekly cleaning of the detergent dispenser will ensure
problem free operation.

Cleaning the Dispenser

1. The dispenser should be cleaned periodically to remove
buildup from detergent and other laundry products.
2. Remove the inserts from the drawer, and clean them
with warm water and a soft cloth or brush to remove any
residue or buildup.
Wipe out the inside of the drawer opening with a damp
cloth. Reassemble the drawer and reinstall in the drawer
opening.
NOTE
• Do not use anything other than water to clean the
drawer, inserts, and drawer opening.