Parts Replacement - Toshiba TDP-D1 Service Manual

3.1 Lamp module
The lamp module is located at bottom of the projector. The lamp module behinds the lamp cover
with 3 captive screws. After you replace the lamp module, you should reset the lamp hour counter.
The switch interrupts power supply output to the projector if you remove the lamp cover.
WARNING Allow the projector to cool before removing the lamp module. The lamp module
becomes very hot when the projector is in use. DO NOT touch any part of the lamp
module that is located in the lamp box. Oils from your fingers will cause smudges and
uneven heating of lamp surfaces, resulting in decreased image quality and premature
lamp failure. If the lamp is ruptured or the lamp module is cracked or damaged, be
careful of quartz or glass fragments that could cause personal injury.
1.Remove one screw of lamp cover which is a spring door.
2. Remove the 3 screws from the lamp module.
Chapter 3 Parts replacement
16