Uniden UH8050S Owner's Manual page 12

DIN Installation
Installing the DIN Bracket
1. Remove the 4 front mounting screws to separate the front frame from the DIN
sleeve.
2. Install the DIN sleeve into the DIN slot of your dashboard and secure it by bending
the top and bottom folding tabs.
3. Slide UH8050S into the front frame. Ensure the threaded holes on UH8050S line up
with holes on the front frame.
4. Secure UH8050S onto the front frame using 4 pieces of 6mm screws.
5. Attach the DC power leads to UH8050S and your vehicle. RED goes to a positive (+)
connection on your fuse block while BLACK connects to the vehicle chassis ground
(-).
6. Attach the antenna cable, rear MIC and rear speaker to the back of UH8050S if
using.
7. Make sure all the connections are routed away from any potentially pinching or
slicing sheet metal.
8. Slide the front frame (with UH8050S attached and all cable connections done) back
into the DIN sleeve and secure it using 4 front mounting screws.
If you plan to use the Rear MIC Jack or connect an external speaker
at a later time, expect to remove the unit for ease of making those
connections.
NOTE
UNIDEN UH8050S
12
UHF CB Transceiver