To Attach The Miter Gauge; To Install Tabletop Insert Rings - Craftsman 320.37599 Operator's Manual

TO ATTACH THE MITER
GAUGE (Fig. 9)
The miter gauge has been
shipped completely assembled.
Attach the miter gauge to the
table by placing the miter gauge
bar in the slot on the table.
TO iNSTALL TABLETOP iNSERT
RINGS (Fig. 10}
This router table includes three
tabletop insert rings with the
following hole sizes:
• 1-1/4 in. diameter, for use
with bits with diameters up to
1-1/8 in.
1-1/2 in. diameter, for use
with bits with diameters up to
1-3/8 in.
1-3/4 in. diameter, for use
with bits with diameters up to
1-5/8 in.
Fig. 9
Fig. 10
1-1/4 in.
d__1-1/2 in.
1-3/4 in.
o
o
Make sure that the size of the hole
is 1/8 in. larger than that of the bit.
1. Unplug and remove the router.
2. Position the tabletop insert rings over the insert opening in the router table.
3. Press the insert rings into the inset opening in the router table.
4. Press down evenly over the tabs until the insert ring locks into place.
5. To remove, pull up gently until the tabs disengage. When not in use, store
tabletop inserts in a convenient place.
37599 Manual_Revised_12 1219 Page 17