To Use The Pressure Gauge Feature; To Switch From Psi, Kg/Cm And Bar; To Set Pressure Gauge For Automatic Shut Off - Craftsman 315.115860 Operator's Manual

PRESSURE
GAUGE (+)
BUTTON
(=)
BUTTON
ON/BESET
BUTTON
Fig. 16
To turn the digital gauge ON, press the ON/RESET button
or depress the switch trigger.
NOTE: Make sure digital gauge is set at 0 before use. If
gauge reads "Err" or needs resetting, press and hold ON/
RESET button for 3-6 seconds.
NOTE: The digital gauge will automatically shut off when
not in use for 2 1/2 minutes or more.
To use the pressure gauge feature:
[] Turn digital gauge on by pressing ON/RESET button or
depressing and releasing switch trigger.
[] Place air chuck over valve stem and press down.
Readout will appear on gauge.
If inflating, the air pressure will appear on the gauge as the
item is being inflated.
To switch from PSI, KG/OM 2,and BAR:
[] With gauge ON, press and hold down ON/RESET
button for at least 6 seconds.
[] The current measuring unit will flash. Press the ON/
RESET button to select the desired measuring unit.
[] The setting takes effect 5 seconds after the display
stops flashing.
To set pressure gauge for automatic shut off:
[] With gauge ON, press and hold down ( + ) or ( = )
buttons to select desired shutoff pressure.
NOTE: Numbers will flash while setting pressure.
Holding buttons down will make the pressure number
increase faster.
[] When desired setting has been selected, begin
inflating. Handheld inflator will shut off once setting is
reached.
NOTE: If using the lock-on button with a preset
pressure setting, the unit will stop after the item being
inflated has reached 40 PSI, 2.75 BAR, or 2.80 KG/
CM 2.
The lock-on feature must then be disengaged, and
the switch trigger must be held manually for pressures
over 40 PSI, 2.75 BAR, or 2.80 KG/CM 2.
AIR
PRESSURE
(') (+)
BUTTON BUTTON
ON/BESET
BUTTON
Fig. 17
15