Positioning The Printer - Kyocera FS-9100DN Installation Manual

3 Positioning the Printer

Make sure that the place of installation meets the following requirements:
Clearance
15
Rear: 10 cm (3 - / ")
16
Left: 60 cm
5
(23 - / ")
8
3
Front: 100 cm (39 - / ")
8
Environment
Temperature
10 to 32.5 °C (50 to 90.5 °F), ideally about 23 °C (73.4 °F)
Humidity 20 to 80 %, ideally 60 %
Do not install the printer where temperature or humidity is outside the recommended
range. Print quality may suffer and there will be an increased chance of paper jams.
Places to Avoid
Avoid installing the printer in locations subject to:
• Direct drafts of hot or cold air
• Direct drafts from outside (Avoid locations near building entrances.)
• Sudden temperature or humidity changes
• Sources of high temperature, for example, near stoves or radiators
• Excessive dust
• Vibration
• Unstable surfaces and surfaces that are not level
• Ammonia or other harmful fumes (If you are planning to fumigate the room, or make liberal
use of insecticide, remove the printer first!)
• Excessive sunlight or humidity
• Lack of ventilation
• Low air pressure, e.g. elevations greater than 2000 meters (6500 feet) above sea level

Right: 70 cm
9
(27 - / ")
16
Be sure to secure enough
space around the printer.
Prolonged use without suffi-
cient clearance may cause
heat to build up within the
printer, resulting in fire.