Section 2: Getting Started; Design, Installation & Location Considerations; Fire Safety - Quadra-Fire YOSEMITE-MBK Owner's Manual

Yosemite non-catalytic, front/side load, wood heater
Hide thumbs Also See for YOSEMITE-MBK:
Table of Contents

Advertisement

2
Getting Started
A. Design, Installation & Location Consider ations
Consideration must be given to:
Safety
Convenience
Traffi c fl ow
Chimney and chimney connector required
It is a good idea to plan your installation on paper, using exact
measurements for clearances and fl oor protection, before
actually beginning the installation. If you are not using an
existing chimney, place the appliance where there will be a
clear passage for a factory-built listed chimney through the
ceiling and roof.
We recommend that a qualifi ed building inspector and your
insurance company representative review your plans before
and after installation
If this appliance is in an area where children may be near it
is recommended that you purchase a decorative barrier to go
in front of the appliance. Remember to always keep children
away while it is operating and do not let anyone operate
this appliance unless they are familiar with these operating
instructions.
CAUTION
Check building codes prior to installation.
• Installation MUST comply with local, regional, state and
national codes and regulations.
• Consult insurance carrier, local building, fi re offi cials or
authorities having jurisdiction about restrictions, installation
inspection, and permits.
Asphyxiation Risk.
DO NOT CONNECT THIS UNIT TO A CHIM-
NEY FLUE SERVICING ANOTHER APPLI-
ANCE.
• DO NOT CONNECT TO ANY AIR DISTRIBU-
TION DUCT OR SYSTEM.
May allow fl ue gases to enter the house.
October 13, 2015
R
WARNING
B. Fire Safety
To provide reasonable fi re safety, the following should be
given serious consideration:
1.
Install at least one smoke detector on each fl oor of
your home to ensure your safety. They should be
located away from the heating appliance and close
to the sleeping areas. Follow the smoke detector
manufacturer's placement and installation instructions,
and be sure to maintain regularly.
2.
A conveniently located Class A fi re extinguisher to
contend with small fi res resulting from burning embers.
3.
A CO detector should be installed in the room with the
appliance.
3.
A practiced evacuation plan, consisting of at least two
escape routes.
4.
A plan to deal with a chimney fi re as follows:
In the event of a chimney fi re:
a
Evacuate the house immediately
b.
Notify fi re department
Fire Risk.
Hearth & Home Technologies disclaims any
responsibility for, and the warranty will be
voided by, the following actions:
• Installation and use of any damaged appliance.
• Modifi cation of the appliance.
• Installation other than as instructed by Hearth & Home
Technologies.
• Installation and/or use of any component part not
approved by Hearth & Home Technologies.
• Operating appliance without fully assembling all
components.
• Operating appliance without legs attached (if supplied
with unit).
• Do NOT Overfi re - If appliance or chimney connector
glows, you are overfi ring.
Any such action that may cause a fi re hazard.
Fire Risk.
Do not operate appliance before reading and
understanding operating instructions.
Failure to operate appliance properly may
cause a house fi re.
7004-187L
Yosemite Wood Stove
WARNING
WARNING
Page 5

Advertisement

Table of Contents
loading

This manual is also suitable for:

Yosemite-pmh

Table of Contents