Air Filter Check; Air Filter And Cleaning; Assembly - Husqvarna 2013 CR 125 Owner's Manual

AIR FILTER CHECK

Turn rear pin (1) counterclockwise, remove the saddle from the
front afstening screw.
Remove screw (3) and the filter (4). Separate filter (5) from
frame (6).
3
EN - 24 SPECIFICATIONS - OPERATION - MAINTENANCE

AIR FILTER AND CLEANING

Wash the filter with a specific detergent (CASTROL FOAM AIR
FILTER CLEANER or similar) then dry it fully (wash filter with
gasoline only in case of necessity).
Plunge the filter in special oil for filters (CASTROL FOAM AIR
FILTER OIL or similar) then wring it to drain superfluous oil.
CAUTION*: Do not use gasoline or a low flash-
point solvent to clean the element. A fire or
explosion could result.
CAUTION*: Clean the element in a well ven-
tilated area, and do not allow sparks or
flames anywhere near the working area.
1
4
5

ASSEMBLY

To ensure tight fit, slightly (C) grease filter edge on side facing
filter housing.
While re-inserting the filter into its housing, make surs that piece
(A) is turned upwards and edge (B) is on the left lower side of
the filter case. Reassemble the parts previously removed (bat-
tery: connect the positive cable first).
CAUTION*: If the element assembly is not
installed correctly, dirt and dust may enter
and the engine resulting in rapid wear of the
piston rings and cylinder.
6
C
A
B