Brake Pads Removal; Pads Wear; Pads Cleaning; Pads Installation - Husqvarna 2013 CR 125 Owner's Manual

BRAKE PADS REMOVAL

- Remove springs (1).
- Remove pins (2).
- Remove pads.
CAUTION!
Don't operate the brake lever or pedal while
removing the pads.
2
1
1
REAR

PADS WEAR

Inspect pads for wear.
Service limit " A" is: 3,8 mm (0.15 in.).
If service limit is exceeded, always replace the pads in pairs.
FRONT
2
FRONT
A A
REAR
SPECIFICATIONS - OPERATION - MAINTENANCE

PADS CLEANING

Be careful that no disc brake fluid or any oil gets on brake pads
or discs. Clean off any fluid or oil that inadverently gets on the
pads or disc with alcohol.
Replace the pads with new ones if they cannot be cleaned sat-
isfactorily.

PADS INSTALLATION

- Install new brake pads.
- Reassemble the two pins (2) and the springs (1).
WARNING!
Do not attempt to ride the motorcycle until
the brake lever or pedal are fully effective.
Pump the brake lever or pedal until the pads
are against the discs.
The brake will not function on the first ap-
plication of the lever or pedal.
2
FRONT
1
REAR
1
2
EN - 39