Select Map; Signpost Information; Speed; Auto Mode - Blaupunkt TravelPilot Lucca 5.2 Operating And Installation Instructions

Confi guring Lucca

Select map

In the Select map menu, you can select a different
map material. This function is only available if you
saved map material on the SD card.
u
Touch the Select map button and select a
map by touching it.

Signpost information

In the Signpost information menu, you can specify
whether signpost information, which you are to
follow, should be displayed during the navigation
or not.
u
On the second page of the Settings menu,
touch the Signpost information button.
u
Touch the Show traffi c signs button to switch
the display on or off.
u
Touch OK.
Note:
This information can only be displayed if it is
part of the map material.

Speed

In the Speed menu you can defi ne whether speed
limits should be displayed during the navigation
and whether you should be warned audibly if you
are exceeding the speed limit.
u
On the second page of the Settings menu,
touch the Speed button.
The Speed menu is displayed.
You can now select the following settings:
• Display signs
u
Touch the Show traffi c signs button to
change between the following modes:
– Always
– On speeding only
– Never
36
• Warning in urban areas
– The Warning in urban areas button
shows the level of the speed-reading at
which you are audibly warned inside of
build-up areas.
u
Touch the Warning in urban areas to change
the value or to set it to Never.
• Warning in rural areas
– The Warning in rural areas button shows
the level of the speed-reading at which
you are audibly warned outside of build-
up areas.
u
Touch the Warning in rural areas to change
the value or to set it to Never.
• Warning
u
Activate the Warning button to receive a warn-
ing for speed limits when wet.
u
Touch OK.
Note:
This information can only be displayed if it is
part of the map material.
Caution:
The information in the map material may be incorrect
due to short-term changes (construction, etc.)!
The traffi c situation and the local signpost infor-
mation have priority over the information of the
navigation system.

Auto mode

In the Auto mode menu, you can perform the fol-
lowing settings:
• Start with
– Select whether the map should be dis-
played in 3-D view or in 2-D view by de-
fault.
• 3D auto zoom
– Select whether you desire Autozoom or
No autozoom as default in 3-D view dur-
ing a navigation.