Programming Additional Transmitters; Transmitter Battery Replacement - Jeep 2015 Wrangler Owner's Manual

• For vehicles not equipped with the EVIC, perform the
following steps:
1. Push the RKE transmitter UNLOCK button for 4 to 10
seconds.
2. While the UNLOCK button is pushed, (after four
seconds) push the RKE transmitter LOCK button.
Release both buttons.
3. Test the "Flash Lights With Lock" feature outside of
the vehicle by pushing the RKE transmitter LOCK
button with the ignition switch in the LOCK position
and the ignition key removed.
NOTE: Pushing the RKE transmitter LOCK button while
you are in the vehicle will activate the Vehicle Security
Alarm. Opening a door with the Vehicle Security Alarm
activated will cause the alarm to sound. Push the RKE
transmitter UNLOCK button to deactivate the Vehicle
Security Alarm.
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 27
The "Flash Lights With Lock" feature can be reactivated
by repeating this procedure.

Programming Additional Transmitters

Refer to Sentry Key® "Customer Key Programming".
If you do not have a programmed RKE transmitter,
contact your authorized dealer for details.

Transmitter Battery Replacement

The recommended replacement battery is CR2032.
NOTE: Perchlorate Material – special handling may ap-
ply. See www.dtsc.ca.gov/hazardouswaste/perchlorate
1. With the RKE transmitter buttons facing down, use a
flat blade screwdriver to pry the two halves of the RKE
transmitter apart. Use extreme care not to damage the
seal or internal components.
I n f o r ma t i o n P r o v i d e d b y :
2