Jeep 2015 Wrangler Owner's Manual page 129

Call Termination
To end a call in progress, momentarily push the
ton. Only the active call(s) will be terminated and if
there is a call on hold, it will become the new active
call. If the active call is terminated by the phone far
end, a call on hold may not become active automati-
cally. This is cell phone-dependent. To bring the call
back from hold, push and hold the
hear a single beep.
Redial
• Push the button to begin.
• After the "Ready" prompt and the following beep, say
"Redial."
• The Uconnect® Phone will call the last number that
was dialed from your mobile phone.
NOTE: This may not be the last number dialed from the
Uconnect® Phone.
Call Continuation
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 127
Call continuation is the progression of a phone call on the
Uconnect® Phone after the vehicle ignition has been
but-
switched to OFF. Call continuation functionality avail-
able on the vehicle can be any one of three types:
1. After the ignition is switched to OFF, a call can
continue on the Uconnect® Phone either until the call
ends, or until the vehicle battery condition dictates
button until you
cessation of the call on the Uconnect® Phone and
transfer of the call to the mobile phone.
2. After the ignition is cycled to OFF, a call can continue
on the Uconnect® Phone for a certain duration, after
which the call is automatically transferred from the
Uconnect® Phone to the mobile phone.
3. An active call is automatically transferred to the
mobile phone after the ignition is cycled to OFF.
I n f o r ma t i o n P r o v i d e d b y :
3