Sensor (Fuser Exit) On Jam - Lexmark W840 Service Manual

4024-XXX
Step
4 Perform a print test.
Does the error continue?

201.00 Sensor (fuser exit) on jam

Step
1 Check the media position.
Does the media touch the sensor (fuser exit)?
Open the printer left door assembly and visually check it.
2 Check the fuser exit actuator.
Does the fuser exit actuator appear to be binding or sticking
in its normal resting position and not allowing media to
pass?
3 Check the roll.
Open the printer left door assembly and check it.
Is the transport roll assembly free of excess wear and
contamination?
4 Inspect the pinch roll on the transfer roll guide assembly
Is the transfer roll guide assembly free of damage?
5 Check the sensor (fuser exit) for proper operation.
1. Enter Diagnostics mode.
2. Select BASE SENSOR TESTS
3. Select MEDIA PATH.
4. Select Fuser exit.
Open the printer left door assembly and check it.
Warning: The area around the actuator is very hot. Allow
the fuser area to cool before proceeding.
Does the display, on the operator panel, change every time
the sensor actuator is operated?
6 Check the sensor (fuser exit) connection.
Is the sensor (fuser exit) properly connected?
2-24
Printer Service Manual
Check
Check
Yes
Replace the Problem solved.
printer engine card
assembly.
Go to "Printer
engine card
assembly
removal" on
page 4-120
Yes
Remove the media Go to step 2.
Replace the fuser Go to step 3.
exit actuator.
Go to "Sensor
(fuser exit)
removal" on
page 4-104.
Go to step 4. Clean or replace
the transport roll
assembly.
Go to"Transfer
roll assembly
removal" on
page
Go to step 5. Replace the
transfer roll guide
assembly.
Go to
roll guide
assembly
removal" on
page
Go to step 7. Go to step 6.
Replace the Replace the
sensor (fuser exit). connection.
Go to "Sensor
(fuser exit)
removal" on
page 4-104.
No
No
4-71.
"Transfer
4-75.