Table of Contents
Advertisement
Advertisement
Chapters
Table of Contents
Related Manuals for Blaupunkt Freiburg RCM 45
Summary of Contents for Blaupunkt Freiburg RCM 45
- Page 1 Radio / Cassette Freiburg RCM 45 Operating instructions...
-
Page 3: Table Of Contents
Contents Short instructions ......18 CD changer control (optional) ..30 Scanning stored stations with Preset Scan ........25 Switching to changer operation Important notes ......21 Sampling all stations to be received with SRC on the car radio ..... 30 with Scan .......... -
Page 4: Short Instructions
Short instructions 1 On 2 LD Volume Loudness - When listening at a low level, the Loudness function creates a more natural sound by boosting the low frequency range. To switch the Loudness on/off: Fader front Press LD. Fader rear For more information, read chapter Balance left This unit can also be switched on and... - Page 5 5 AF - Alternative frequency during RDS ; Display To switch over: Press lo briefly. operation For more information, see chapter Radio operation: When “AF” lights up in the display, the “DSC programming”. radio will automatically search for a frequency offering better reception of 7 MTL the same RDS programme.
- Page 6 < PROG button / Fast winding ? 1, 2, 3, 4, 5, 6 - preset buttons B FM To switch to the other side of the You can store six stations on each FM To switch between the FM memory cassette tape: memory bank (I, II, T).
-
Page 7: Important Notes
Traffic safety Use only the accessory and replacement As the driver of a motor vehicle, it is your Down parts approved by Blaupunkt. responsibility to pay attention to the traffic Up/down in short intervals (“AF” must be switched off) situation at all times. Never use your car radio To scroll through the broadcasting in a way that could distract you. -
Page 8: Keycard Theft-Protection System
KeyCard theft-protection system If a wrong KeyCard is inserted, then “CARD The display will switch to “CHANGE”. This car radio is supplied with one KeyCard blan- as standard. ERR” will appear in the display. In this case • Press the KeyCard in, which releases please do not go on operating the set. -
Page 9: Radio Operation With Rds
Radio operation with RDS (Radio Data System) The Radio Data System offers you more While searching for the strongest reception If you leave the service area of the regional convenience when listening to FM radio sta- signal, the radio may switch to mute briefly. programme tuned into, or if you would like to tions. -
Page 10: Manual Tuning
Manual tuning << >> With this, the requirements for selecting sta- Notice: (prerequisite: AF is switched off!) tions with << >> are fulfilled. Should you tune in a station which has alrea- dy been stored before, the corresponding • Press << >>; the frequency will change preset button and the memory bank will briefly in short intervals in downwards or up- Changing the memory bank... -
Page 11: Scanning Stored Stations With Preset Scan
Scanning stored stations Switching from stereo to mono To select a station currently being scan- with Preset Scan ned and switch off the scan function: If reception is poor, you may get better sound • Press SC briefly. quality by switching to mono: •... -
Page 12: Receiving Traffic Programme Stations With Rds-Eon
Receiving traffic programme stations with RDS-EON Traffic announcement priority Many FM broadcasters offer traffic messa- Alternatively: on/off ges for their service area at regular intervals. b) Switch off the priority for traffic an- All traffic programme stations transmit a nouncements: If the priority for traffic announcement pro- special carrier signal alongside their pro- •... -
Page 13: Tape Operation
Tape operation Inserting a tape Tape equalisation with MTL other side (Autoreverse). The display shows “TR1---...” for track (side) 1 or A or “TR2---...” Switch on the MTL function to select the best • Turn on the set. for track 2 or B. equalisation response when using metal or •... -
Page 14: Tape Care
DSC programming Tape care DSC (Direct Software Control) allows you to (lo off) customise certain programmable, basic set- To adjust the seek tuning To avoid possible problems, you should not tings to suit your personal needs and prefe- sensitivity for distant recep- use cassette tapes longer than 60 or 90 rences and then store them. -
Page 15: Overview Of The Dsc Factory Settings
Overview of the DSC factory BEEP Confirmation tone for all LOUD Loudness - When listening settings functions which require a at a low level, the Loud- button to be pressed for ness function creates a LOCAL more than 2 seconds. more natural sound by The volume can be adju- boosting the low frequency... -
Page 16: Cd Changer Control (Optional)
CD changer control (optional) Track using the rocker switch / You can operate the Blaupunkt CD changer To stop the SCAN: Selecting a disc CDC-A05 in combination with this car radio. • Press the SC button briefly once again. The system will continue to play the Switching to changer operation currently scanned track. -
Page 17: Appendix
Appendix Specifications Amplifier Output power: 4 x 6 W RMS power acc. to DIN 45324/3.1 4 x 8 W max. power acc. to DIN 45324/3.2 FM waveband 1,0 µV at 26 dB Sensitivity: signal-to-noise ratio Frequency response: 35 - 16 000 Hz Tape player Frequency response:... - Page 18 Blaupunkt-Werke GmbH Bosch Gruppe 4/95 Pf K7/VKD 8 622 400 020...