Table of Contents
Advertisement
TRENDnet User's Guide
Troubleshooting
Q:
I typed http://192.168.10.200 in my Internet Browser Address Bar, but
an error message says "The page cannot be displayed." How can I access
the switch management page?
A:
1. Check your hardware settings again.
2. Make sure the Power and port Link/Activity lights are lit.
3. Make sure your network adapter TCP/IP settings are set to use the
static IP.
4. Make sure your computer is connected to one of the Ethernet switch
ports.
5. Since the switch default IP address is 192.168.10.200, make sure
there are no other network devices assigned an IP address of
192.168.10.200
Q:
If my switch IP address is different than my network's subnet, what
should I do?
© Copyright 2015 TRENDnet. All Rights Reserved.
A:
You should still configure the switch first. After all the settings are
applied, go to the switch configuration page, click on System, click IPv4
Setup and change the IP address of the switch to be within your
network's IP subnet. Click Apply, then click OK. Then click Save Settings
to Flash (menu) and click Save Settings to Flash to save the IP settings
to the NV-RAM.
Q:
I changed the IP address of the switch, but I forgot it. How do I reset my
switch?
A:
Using the TRENDnet Switch Management Utility to find your smart
switch. Or, you can reset your smart switch to factory default.
To reset the smart switch, using a paper clip, push and hold the reset
button on the front of the switch and release after 15 seconds. The default
IP address of the switch is 192.168.10.200. The default user name and
password is "admin".
TPE-4840WS
122
Advertisement
Table of Contents
