Use Browser-Based Access To Assign A Pvid To A Port - NETGEAR ProSAFE GSS108E User Manual

4. Click the APPLY button.
You are asked to enter the password for the switch.
5. Enter the switch's password in the password field.
The switch's default password is password.
The Switch Status screen displays.
6. Select VLAN > 802.1Q > Advanced > PVID.
The Port PVID screen displays.
7. Select a port.
8. Enter the PVID.
9. Click the APPLY button.
Your settings are saved.

Use Browser-Based Access to Assign a PVID to a Port


To assign a PVID to a port:
1. Set up your computer to use an IP address in the same subnet as the IP address of the
switch.
2. Use an Ethernet cable to connect your computer to an Ethernet port on the switch.
3. Launch a web browser.
4. In the address field of the browser, enter the IP address of the switch.
You can find the IP address of the switch by using the ProSAFE Plus utility or get it from
the DHCP server. If the switch cannot get an IP address from a DHCP server, enter
192.168.0.239.
You are asked to enter the password for the switch.
5. Enter the switch's password in the password field.
The switch's default password is password.
The Switch Information screen displays.
6. Select VLAN > 802.1Q > Advanced > Port PVID.
The Port PVID screen displays.
7. Select a port.
8. Enter the PVID.
9. Click the Apply button.
Your settings are saved.
ProSAFE 8-Port and 16-Port Gigabit Click Switch
Use VLANS for Traffic Segmentation
49