Set Up Link Aggregation Groups; Use The Prosafe Utility To Enable Lags - NETGEAR ProSAFE GSS108E User Manual

Hide thumbs Also See for ProSAFE GSS108E:

Table of Contents

Make sure that the IGMP Snooping Status Enable radio button is selected.

In the VLAN ID Enabled for IGMP Snooping field, type the name of the VLAN.

Click the Apply button.

Your settings are saved.

Set Up Link Aggregation Groups

Link aggregation groups (LAGs) allow you to combine multiple Ethernet links to a single

logical link. Network devices treat the aggregation as if it were a single link, which

increases fault tolerance and load sharing. Configure LAG membership before you

enable the LAG.

Note:

LAGs are supported in switch model GSS116E, but they are not

supported in switch model GSS108E.

You must set up LAG membership before you enable LAG.s



To enable LAGs:

Connect your computer to the same network as the switch.

You can use a WiFi or wired connection.

Double-click the ProSAFE Plus Utility icon.

The configuration home screen displays a list of Plus switches that it discovers on the

local network.

Select a switch.

If you do not see the switch, click the REFRESH button.

Click the APPLY button.

You are asked to enter the password for the switch.

Enter the switch's password in the password field.

The switch's default password is password.

The Switch Status screen displays.

ProSAFE 8-Port and 16-Port Gigabit Click Switch

Network Settings

Table of Contents

Prosafe gss116e