Factory Default Settings - NETGEAR ProSAFE GSS108E User Manual

Factory Default Settings

You can return the switch to its factory settings. Use the end of a paper clip or some other
similar object to press and hold the /Factory Defaults button on the back panel of the switch
for at least four seconds. The switch resets, and returns to the factory settings that are shown
in the following table.
Table 2. Factory default settings
Factory Default Setting
Switch name
Switch password
IP address
Subnet mask
Gateway address
DHCP mode
Port mirroring
Loop detection
IGMP snooping
Port LED control
LAG
VLAN
QoS
Rate limit
Broadcast filtering
Port mode
Flow control
ProSAFE 8-Port and 16-Port Gigabit Click Switch
GSS108E
N/A (empty)
password
192.168.0.239
255.255.255.0
192.168.0.254
Enabled
Disabled
Disabled
Enabled
Link speed and activity
N/A
Disabled
802.1p/DSCP based
Disabled
Disabled
Auto negotiation
Disabled
Supplemental Information
73
GSS116E
N/A (empty)
password
192.168.0.239
255.255.255.0
192.168.0.254
Enabled
Disabled
Disabled
Enabled
Link speed and activity
Disabled
Disabled
802.1p/DSCP based
Disabled
Disabled
Auto negotiation
Disabled