Table of Contents
Advertisement
16. Take out the water tank and reposition the water softener
filter, if removed previously. Press "Yes" to continue;
17. Fill the tank with fresh water up to the MAX level, return it
to the machine and press "Yes" to continue;
18. Having emptied the container used previously to collect
the descaler solution, reposition it under the spouts and
press "Yes" to start another rinsing cycle;
19. When the water in the tank has run out, empty the con-
tainer used to collect the rinsing water, then remove,
empty and reposition the drip tray (A14) and the grounds
container (A10) and press "Next";
20. Take out the water tank, top up to the max level and repo-
sition in the machine;
21. The descaling procedure is now complete: press "OK". The
appliance performs a rapid preheat cycle and then goes
back to the homepage.
Please note:
•
If the descaling cycle is not completed correctly (e.g. elec-
trical power failure) it is advisable to repeat the procedure;
•
Water may find its way into the grounds container (A10)
during the descale cycle: this is quite normal.
•
If the water tank has not been refilled to the MAX level,
the machine prompts for a third rinse to ensure that the
descaler solution has been completely eliminated from
the internal circuits. Before starting the rinse, remember to
empty the drip tray.
15. WATER SOFTENER FILTER
15.1 Installing the filter
To install the filter, proceed as follows:
1. Press the settings menu (C6);
2. Scroll through the pages until the item "Water filter" is
displayed;
3. Press "Read more";
4. Press "Yes" to initiate the guided procedure
5. Proceed from point (3) of heading "Installing the filter" in the
section "Operating the appliance for the first time".
Please note:
The filter lasts about two months assuming normal use of the ma-
chine; if on the other hand the machine remains idle with the filter
installed, it will not last more than three weeks, at most.
15.2 Replacing or removing the filter
Replace the filter (D4) when the corresponding message appears
on the homepage (C): to replace the filter immediately, press "Yes"
and follow the instructions from point (3). To delay replacement
of the filter until later, press "Cancel": the display will continue to
show the corresponding symbol
needs replacing.
as a reminder that the filter
To replace, proceed as follows:
1. Press the settings menu (C6);
2. Scroll through the pages until the item "Water filter" is dis-
played, and press "Read more";
3. Press "Yes" to initiate the guided procedure;
4. Remove the water tank (A9) and the spent filter.
5. To remove the filter, press "Ok";
6. To install a new filter, press "Yes". Proceed with the operations
illustrated under heading "Installing the filter" in section "Op-
erating the appliance for the first time" from point (3).
Please note:
After two months (see date indicator), or after 3 weeks if the ap-
pliance has not been used, the filter should be replaced even if the
warning message has not yet been displayed.
16. TECHNICAL DATA
Voltage:
Power:
Pressure:
Water tank capacity:
Size LxDxH:
Cord length:
Weight (varies according to model):
Beans container capacity:
De'Longhi reserves the right to modify the technical specification
and styling of its products at any moment, without compromising
their functionality and quality.
16.1 Tips for Energy Saving
•
To reduce energy consumption, after delivering one or more
drinks, remove the milk carafes or accessories.
•
Set auto-off to 15 minutes (see section "6.5 Auto-off");
•
Enable Energy Saving (see paragraph "6.4 General");
•
Always carry out the descaling cycle when prompted by the
machine.
20
220-240 V~ 50-60 Hz max. 10 A
1450 W
1.9 MPa (19 bars)
260x450x385 mm
1200 mm
11.2 kg
300 g
1.8l
Advertisement
Table of Contents
Troubleshooting
