Battery Case; Optional Battery Case (Bp-226) - Icom IC-F61M Instruction Manual

Uhf marine transceiver

Hide thumbs Also See for IC-F61M:

Table of Contents

When using the optional battery case attached to the transceiver,

install 5 × AA (LR6) size alkaline batteries as illustrated at right.

q Hook your finger under the latch, and open the cover in the direc-

tion of the arrow (q). (Fig.1)

w Install 5 × AA (LR6) size alkaline batteries. (Fig.2)

• Install the alkaline batteries only.

• Be sure to observe the correct polarity.

• Be sure to pin the ribbon under the batteries. Leave enough of the

ribbon ends extended, to pull when removing the batteries.

e Close the cover by fitting in the direction of the arrow (w) first,

then check that the latch is in place (e). (Fig.1)

• Be sure the gasket and the ribbon are seated correctly, and do not

protrude from the battery case. (Fig.3)

CAUTION:

• When installing batteries, make sure they are all the same

brand, type and capacity. Also, do not mix new and old batter-

ies together.

• Keep battery contacts clean. It's a good idea to occasionally

clean them.

• Never incinerate used battery cells since internal battery gas

may cause them to rupture.

• Never expose a detached battery case to water. If the battery

case gets wet, be sure to wipe it dry before using it.

BATTERY CASE

Table of Contents