Advertisement
LCD Remote Programming
Press Buttons at the Same Time: Then Press Button Within:
+
+
+
+
+
Battery Replacement
(Applies to LCD Transmitter Only)
Interference
The transmission range may decrease if the system encounters interference from tall structures or
stronger radio frequencies such as high-voltage power lines.
LED Indicator
LED
Function
OFF
System is Disarmed
Slow Flashing
System is Armed
Fast Flashing
System in Automatic Arming
1 Flash Every 5 Seconds
System in Valet Mode (Ignition Key On or Off)
2 Flashes - Pause
Zone 2, Trigger on Trunk/Hook
3 Flashes - Pause
Zone 3, Trigger on Door Switch
4 Flashes - Pause
Zone 4, Trigger on Shock Sensor
5 Flashes - Pause
Zone 5, Trigger on Ignition Switch
6
System Function
Switching to 2nd Vehicle
5 Sec.
or Returning to 1st
Vehicle Operation
Melody / Vibration Mode
5 Sec.
Power Save Mode
5 Sec.
LCD Screen Lamp
Turns On for Five Seconds
System Status Check
3 Sec.
Clear the Flash Icon
3 Sec.
and Melody Sound
The LCD remote control is powered by a 1.5 Volt AAA
Alkaline battery. When the power of the battery
weakens the battery icon
screen. When the old battery is replaced with a new
one, there will be a beep to indicate the power is up. To
replace the battery, follow the steps in the illustration
at left.
Note: Press the
button two times when the battery
compartment is empty, then insert the new battery.
will be displayed on the
Advertisement
