Marksman Extreme X9 Owner's Manual page 11

Extreme series automotive security and remote start system

Hide thumbs Also See for Extreme X9:

Panic Feature

The transmitter can be used as a remote panic switch to manually trigger the alarm system in

case of an emergency.

1. Press and hold the

button for 3 seconds to enter the Panic Mode (horn/siren will start to

sound and parking lights will flash).

2. While in Panic Mode the transmitter

(if that option is installed). However, if the

device (when installed) will be disabled, allowing the vehicle to start.

3. To turn off the panic function, press and hold the

Note: If any transmitter buttons other than or button is pressed the panic function will be

turned off.

4. If the panic function is not turned off by the transmitter, it will turn off and reset itself after 30

seconds.

Domelight Supervision

The Security System has a unique feature for using your vehicle's dome light:

1. Upon disarming the vehicles security system, the interior dome light will remain on for 30

seconds.

2. If the security system is triggered, the dome light will flash for the same duration as the

horn/siren.

Note: Turn "ON" the ignition switch or arm the system to turn off the dome light.

Ignition Key Controlled Door Lock/Un-Lock

If the vehicles door locks have been interfaced with the security system, the system will

automatically lock the doors when the ignition is turned "ON", or unlock the doors when ignition

key is turned "OFF".

Channel #3 Trunk Release Output

Press and hold the

button for two seconds to activate the trunk release (Channel 3 output)

and/or any other devices connected.

Channel #4 Timer Controlled Output

Press and hold the

and

is user programmable timer output. You may program the built-in timer to send a ground signal

for any time duration from 1 second to 120 seconds. For example, this timer output may be used

to turn on the headlights, power window or sunroof (Factory defaults setting at momentary

output.)

and

buttons can be used to lock and unlock the door

button is pressed, the vehicle's starter disable

or button again for 3 seconds.

button at the same time to activate the Channel 4 output. Channel 4