Precor 9.23 Owner's Manual page 9

• Never leave the equipment unattended when it is
plugged in. Unplug the equipment from its power
source when it is not in use, before cleaning it, and
before providing authorized service.
Note: The optional power adapter is considered a
power source for self-powered equipment.
• Use the power adapter provided with the equipment.
Plug the power adapter into an appropriate, grounded
power outlet as marked on the equipment.
• Care should be taken when mounting or dismounting
the equipment.
• Read, understand, and test the emergency stop
procedures before use.
• Keep the power cord or optional power adapter and
plug away from heated surfaces.
• Route power cables so that they are not walked on,
pinched, or damaged by items placed upon or against
them, including the equipment itself.
• Ensure the equipment has adequate ventilation. Do not
place anything on top of or over the equipment. Do not
use on a cushioned surface that could block the
ventilation opening.
• Assemble and operate the equipment on a solid, level
surface.
Owner's Manual: Important Safety Instructions
• Proper Location for Equipment
• For all equipment other than treadmills: Locate at
least 40 inches (1 meter) away from walls or furniture
on either side of the equipment, and 40 inches (1
meter) away from objects behind the equipment.
• For treadmills: Locate at least 40 inches (1 meter)
away from walls or furniture on either side of the
treadmill, and at least 80 inches (2 meters) away
from objects behind the treadmill.
• Keep equipment away from water and moisture. Avoid
dropping anything on or spilling anything inside the
equipment to prevent electric shock or damage to the
electronics.
• Do not operate electrically powered equipment in
damp or wet locations.
• Never operate this equipment if it has a damaged cord
or plug, if it is not working properly, or if it has been
dropped, damaged, or exposed to water. Call for
service immediately if any of these conditions exist.
• Maintain the equipment to keep it in good working
condition, as described in the Maintenance section of
the assembly and maintenance guide. Inspect the
equipment for incorrect, worn, or loose components,
and then correct, replace or tighten prior to use.
3