Active Arming: Lock & Arm - Marksman M12A User Manual

Active Arming: Lock & Arm
1. Press the button on the transmitter.
2. The siren will chirp once and parking lights will flash once indicating that the system is now
armed. The vehicle door will lock upon arming when interfaced with the security system.
System Armed
Defective Sensor Reminder:
If the siren sounds 3 times, there is a Door, Trunk, or Hood left open. (See Alarm Feature I-4)
Silent Arming/Disarming:
Press the transmitter
No chirp sound will be heard, arm/disarm confirmation will be through the vehicles
parking lights only.
Shock Sensor Bypass:
Press the button on the transmitter two times within 3 seconds. This will arm the security
system and bypass the shock sensor. The system will chirp one additional time to confirm the
sensor bypass mode was activated. The sensor bypass feature is programmed to activate for one
arming cycle only. The security system will return to normal operation during the
next arming cycle.
Passive Arming:
Active arming/disarming is controlling your security system via the remote transmitter. This
security system is equipped with an optional passive arming feature which allows the security
system to arm 30 seconds after the last door is closed. Operation is as follows:
1. Turn the ignition to the "OFF" position and exit the vehicle.
2. After all entrances are closed, the security system LED will flash fast for 30 seconds. If you
reopen any Door, Hood, Trunk, the security system LED will stop flashing. It will begin flashing
again once the vehicles entrances are closed.
3. After the 30-second timer has elapsed, the security system will automatically "ARM". The
siren/horn will chirp once and the parking lights will flash once also.
Passive Arming with Passive Door Locking (See Alarm Feature 1-2 Programming)
The vehicle doors will automatically lock after passive arming cycle has been completed.
Passive Arming Bypass
While the system is in disarmed mode, press the
with one chirp and the LED will turn "ON". The security system will remain in this mode for as
long as you wish. To exit this mode press the
status.
6
Door Ajar
or button at the same time will arm or disarm your security system,
Trunk/Hood Ajar
button twice. The horn/siren will respond
or buttons and the system will return to normal
Clear the Flash Icon:
Press the SET button 3 times
within 3 seconds to clear the
flash icon on the LCD screen
transmitter.