Table of Contents
Advertisement
Valet Mode
(System in Disarm or Valet Mode)
The valet switch allows you to temporarily bypass all alarm functions eliminating the need to hand
your transmitter to parking attendants or garage mechanics. When the system is in valet mode, all
alarm functions and remote start functions are bypassed, however the remote panic feature and
remote door locks will remain operational. To use the valet mode, the system must first be
disarmed either by using your remote transmitter, or by operating the manual override sequence.
Enter the Valet Mode:
1. In the disarmed mode, turn the ignition to "ON"
position.
2. Push and hold the valet switch for 2 seconds
until the LED turns on solid. The LED will
remain on solid while the unit is in the valet
mode.
Exit the Valet Mode:
1. To return to normal operation, turn "ON" ignition.
2. Push and hold valet switch for 2 seconds. The LED will turn off to indicate the system is now
out of the valet mode.
Car Locator
While in the armed mode, press the
chirp six (6) times. The parking lights will flash 12 times to help you locate your car.
Panic Function
The transmitter can be used as a remote panic switch to manually trigger the alarm system in case
of an emergency.
1. Press and hold the
the parking lights will begin to flash.
2. During panic mode, the normal functions of this transmitter becomes temporarily inoperable.
The transmitter
(if the option is installed), however, once the
disable device, (where installed) will be enabled allowing the vehicle to start.
3. To stop the alarm, press and hold the transmitter
transmitter again for 3 seconds. Also, if any transmitter button other than
release, the panic mode will be turned off immediately.
4. If the button is not pressed, the alarm will automatically stop after 30 seconds.
Trigger the System
When armed, your vehicle is protected as follows:
1. Light impact will trigger the warn-away signal.
2. Heavy Impacts/Doors Open/Hood Open/Trunk Open/Ignition Key Activated will trigger the
programmed sequence. The starter disable relay (if installed) prevents the vehicle's starter from
cranking. The siren, horn, parking lights and dome light will turn on to alert of an intrusion for
60 seconds. If one of the sensors or detectors are still active, the security system will sound a
maximum of 6 times for 30 seconds.
8
button to activate car locator function. The siren/horn will
button for 3 seconds. The security system will begin to sound and
and
buttons can be used to lock and unlock the door
Remote Door Lock
button is pressed, the vehicle's starter
or
Remote Door Unlock
buttons on the
or
is pressed and
Advertisement
Table of Contents
