Power Failure - Thermador Pro Grand User Manual

To Replace the Steam Oven Light Bulb
Heat-resistant 120V / 25 Watt halogen bulbs with seals can
be purchased through retail stores or customer service.
When purchasing through customer service provide the
appliance model and serial numbers.
1. Turn off power to the appliance at the main power
supply (breaker box) or unplug the power cord.
2. Turn the cover to the left to remove.
3. Remove the bulb and replace with the same type of
bulb.
4. Slip the new seals and tension ring onto the glass
cover.
5. Screw the glass cover with seals back on.
6. Reconnect the appliance to power and reset the clock.
Never operate the appliance without the glass cover or
seals.
Replacing the Glass Cover or Seals
Damaged glass covers or seals must be replaced. Provide
customer service with the appliance model and serial
numbers.
Intermittent or Constant Igniter Sparking
Intermittent or constant sparking of the sealed gas surface STAR burners can result from a number of preventable
conditions. Eliminate these conditions as indicated in the following chart.
SYMPTOM
Intermittent sparking
More than four clicks of
igniter before lighting
Constant Sparking
CAUSE
• Ceramic igniter is wet or dirty.
• STAR burner ports are clogged.
• Improper fit of STAR burner cap
onto STAR burner base.
• Range is not properly grounded.
• Electrical power supply is
polarized.

Power Failure

In the event of a power failure, only the non ExtraLow
burners (see page 19 for burner layout) can be lit manually.
It is necessary to light each standard STAR
individually.
If the range's cooktop is being used when the power failure
occurs, turn all of the STAR burner control knobs to the
OFF position. The standard STAR burners can be lit
by holding a match at the ports and turning the control knob
to the HI position. Wait until the flame is burning all the way
around the STAR burner cap before
the desired height.
The four ExtraLow STAR burners on the outer sides cannot
be used during a power failure. Be sure to turn them OFF if
a power failure occurs because they will not turn back on
until the control knobs are turned OFF and then turned
back on again. See "WHAT TO DO IF YOU SMELL GAS"
on page 3.
If you have low gas pressure, contact your gas company.
• Carefully dry or clean igniter.
• Clean ports on STAR burner cap with a
wire, a needle or straightened paper clip.
• Align STAR burner cap properly on
STAR burner base.
• Refer to Installation Instructions. Have a
qualified electrician ground the range
properly.
incorrectly • Refer to the Installation Manual.
Have a qualified electrician ground the
range properly.
®
®
burner
adjusting the flame to
REMEDY
English 85