Other Mode Settings; Specifying The Audio Input/Output Channels - Roland VC-50HD Owner's Manual

Other mode settings

By setting the mode select switches located on the VC-50HD's side panel, you can select the audio
channels that will be output, and allow remote control from a computer.

Specifying the audio input/output channels

For the SDI embedded audio, only the two specific channels you select will be input and output. Make
settings as follows to specify the channels that will be input and output.
* The VC-50HD does not support HDV/DV four-channel audio. If four-channel audio is input, only the two
channels 1/2 will be selected.
Selecting which two SDI audio channels go into IEEE 1394
Make the following settings to determine which two channels will go to IEEE 1394.
* If SDI is the source, turn switch 1 to OFF.
fig.audio-chart-SDI.eps
OFF
1/2 ch
OFF OFF
ON
5/6 ch
Selecting where your two IEEE 1394 audio channels will be encoded to SDI
Make the following settings to determine which two channels will go to SDI.
* If IEEE 1394 is the source, turn switch 1 to ON.
fig.audio-chart-1394.eps
ON
OFF
1/2 ch
OFF
ON
5/6 ch
OFF OFF
3/4 ch
OFF OFF
ON
7/8 ch
OFF OFF
ON
3/4 ch
OFF
ON
7/8 ch
OFF
ON
OFF
OFF
ON
OFF
27