Securing Car Seat With Vehicle Lap Belt Only; Tightening Vehicle Seat Belt; To Remove Car Seat - Baby Trend Secure Snap Gear 32 CS61 Owner's Manual

Table of Contents

Advertisement

Securing Car Seat in Your Vehicle
10.0
10.6.3 Securing Car Seat WITH
Vehicle Lap Belt only
1. To attach Car Seat with Vehicle Lap Belt
only: Slide the vehicle lap belt into the
Vehicle Belt Path openings and
buckle vehicle seat belt. (Fig 45-1)

10.6.4 Tightening Vehicle Seat Belt

1. Check that lap belt is not twisted.
2. Proper installation of the Car Seat
requires that the vehicle lap belt
be very tight and stay tight.
3. Tighten the vehicle lap belt around the
Car Seat by pushing down hard with your
hand on one side of the Car Seat and
then the other side and pulling on the
vehicle seat belt to tighten. (Fig 45-2)
4. Check that the Car Seat is tightly installed
and secure in the vehicle by performing the
following test every time you use the Car Seat.
Firmly push down and side to side on the
head end of the Car Seat to make sure that
45-1
45-2
45-3
45
45
Securing Car Seat in Your Vehicle
10.0
the vehicle seat belt does not loosen at all and that the vehicle seat
belt is fastened very tightly around the Car Seat. (Fig 45-3) If you
find that the vehicle seat belt loosens or that the seat easily moves
or rotates downward, please see section 8.0 Selecting A Vehicle
Seat Location for the Car Seat to determine if the position you have
selected is adequate and check that you have completed all of the
steps this section. If vehicle belt does not stay tightly adjusted around
base, see vehicle seat belts section. A locking clip may be needed or
you may need to move the base to a different seating location.
DO NOT use this seating location if the Car Seat does
not remain tightly installed in the vehicle seat!
5. Recheck that Car Seat is properly reclined.
Readjust recline if necessary. (Fig 46-1) (See
Section 11.4 Adjust Seat Recline Angle.)
6. Check that toys are removed from carry handle
and then adjust the carry handle to the CARRY
position, storage or non-rocking position.

10.6.5 To Remove Car Seat

1. Unbuckle vehicle seat belt.
2. Remove lap belt from Vehicle Belt Path openings.
3. Remove Car Seat.
(10 kg) and
(10 to 14.5 kg)
46-1
46

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ez flex-loc 32

Table of Contents