IBM 8849 Service Manual page 68

v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v See Chapter 3, "Parts listing, Type 8849 or Type 8491 server," on page 61 to determine which components
are customer replaceable units (CRU) and which components are field replaceable units (FRU).
v If an action step is preceded by "(Trained service technician only)," that step must be performed only by a
trained service technician.
System-error log message
Flash succeeded for x (address : y)
Hard drive x removal detected.
Hard drive x fault
Internal error CPU fault
Invalid userid or password received. Userid is x
LAN: Command mode tamper triggered.
Possible break-in attempt
LAN: Ethernet interface is no longer active
LAN: Ethernet interface is now active
LAN: Telnet tamper triggered. Possible break-in
attempt
LAN: Web Server tamper delay triggered.
Possible break-in attempt
No ISMP gateway defined for the interconnect
network. RSA x is assuming the gateway
OS Watchdog response enabled by x
OS Watchdog response disabled by x
PFA Alert, see preceding error in system error
log.
Possible ASM reset occurred --- reason
unknown
Power off
Power on
PPP_1: Client connected at nnnn bps
PPP_1: User requested to abort PPP interface
PPP[xxx] PPP-Cfg, Local-
IP@=aaa.aaa.aaa.aaa, Remote-
IP@=bbb.bbb.bbb.bbb NetMsk=ccc.ccc.ccc.ccc,
Auth=ddd
Received alert from system x; type: y,
sender's ID: z
Remote access attempt failed
Remote access attempt failed. Invalid userid or
password received. Userid is 'x' from TELNET
client at IP@=yyy.yyy.yyy.yyy
52
IBM xSeries 306m Types 8849 and 8491: Problem Determination and Service Guide
Action
Information only.
Reseat hard disk drive x and restart the server.
1. Run the diagnostics programs.
2. Replace hard disk drive x.
3. Replace the hard disk drive backplane or back panel.
Information only. If the message remains:
1. (Trained service technician only) Reseat the microprocessor.
2. (Trained service technician only) Replace the microprocessor.
Information only.
Information only.
Information only.
Information only.
Information only.
Information only.
Information only.
Information only.
Information only.
Information only. See the preceding entry in the system-error log.
Information only.
Information only.
Information only.
Information only.
Information only.
Information only.
Information only.
Information only.
Information only.