Removing The Sas/Sata Backplane Or Sata Back Panel - IBM 8849 Service Manual

Complete the following steps to install the riser-card assembly.
1. Install the adapters in the riser-card assembly.
2. Reconnect any adapter cables that you disconnected when you removed the
3. Carefully align the riser-card assembly with the guides on the rear of the server

Removing the SAS/SATA backplane or SATA back panel

To remove the Serial Attached SCSI (SAS) backplane, which is also referred to as
the hot-swap SAS/SATA backplane, or to remove the simple-swap SATA back
panel, complete the following steps.
Note: The following illustration shows removing the hot-swap SAS/SATA backplane.
1. Read the safety information that begins on page vii and "Installation guidelines"
92
IBM xSeries 306m Types 8849 and 8491: Problem Determination and Service Guide
riser-card assembly.
and with the riser-card connectors on the system board; then, press down on
the assembly. Make sure that the riser-card assembly is fully seated in the
riser-card connectors on the system board.
on page 69.