Planning A Route Using A Mapcode - TomTom GO Mobile Reference Manual

N 51.51000
51.51000 -0.13454
Tip: For decimal values you don't have to use a letter to indicate the latitude and longitude.
For locations west of the 0 meridian and locations south of the equator, use a minus sign (-)
before the coordinate.

Degrees, minutes and seconds, for example:
N 51°30'31"

GPS standard coordinates, for example:
N 51 30.525
Note: The bar below the coordinates goes red if you enter coordinates that are not recognised by
your GO Mobile.
6. As you type in the coordinates, suggestions are shown based on what you have entered. You can
continue typing or select a suggestion.
Towns and roads are shown on the left, POIs are shown on the right.
Tip: To see more results, hide the keyboard or swipe the results list to scroll it.
Tip: You can switch between seeing the results on the map or in a list by selecting the list/map
button:
7. Select a suggestion for your destination.
The location is shown on the map.
8. To plan a route to this destination, select the drive button:
A route is planned and then guidance to your destination begins. As soon as you start driving, the
guidance view is shown automatically.
Tip: If your destination is in a different time zone, you see a plus (+) or a minus (-) sign and the
time difference in hours and half hours in the
arrival is the local time at your destination.
Tip: You can add a stop to a route
Tip: You can save a route using

Planning a route using a mapcode

Important: In the interest of safety and to avoid distractions while you are driving, you should always
plan a route before you start driving.
To plan a route using a mapcode, do the following:
1. Select the Main Menu button to open the Main Menu.
W 0.13454
W 0°08'34"
W 0 08.569
that you have already planned.
My Routes.
arrival information panel. The estimated time of
45