Final Installation; Rockwool Placement - Vermont Castings 300DVBHNV7 Homeowner's Installation And Operating Instructions Manual

DVBH7 Series Direct Vent Gas Fireplace
plAcemeNt oF lAVA RocK, RocK Wool
AND loGS
1. Before starting, make sure the grate is hooked onto
the rear bracket.
. Sprinkle lava rocks around and in front of burner at
bottom of firebox.
3. Pull the rock wool apart into dime-sized pieces or
smaller. Distribute one thin layer of rock wool over front
ports and carryover ports. Do not cover slots (400) or
large holes (300) at rear of burner. Figures 60 & 61
4. Place the logs on the burner. Refer to Steps 4-10 . Light
the unit and after 15 minutes check burner flame and
glow. Adjust embers as necessary to achieve an even
and clean flame.
300DVBH
400DVBH
Figure 61 -

Rockwool Placement

FP2589
rock wool place
5. Place Rear Log #1 into place by setting the log over
the two pins on the grate toward the back. The two
round holes on the bottom of the logs should go over
the two pins on the grate. Figure 62
4
Figure 60 -
Rockwool Placement
the use of too much rock wool could
cause flame to burn poorly and may cause
sooting.
Do not sprinkle the lava rock or ember
chunks on top of the burner. this may cause
potential sooting, glass breakage and a fire
hazard.
FP589
Figure 62
LG744
HBDV log 1

FINAl INStAllAtIoN

LG743
HBDV rockwool
Rear Log #1
LG744
LG743
54D8001