Glass Frame Removal; Brick Installation - Vermont Castings 300DVBHNV7 Homeowner's Installation And Operating Instructions Manual

GlASS RemoVAl

GlASS FRAme RemoVAl

1. Release two clamps on bottom of fireplace. Figure 59
. Tilt glass frame out and lift glass frame up until it clears
three tabs on top of fireplace.
3. Set glass frame aside.
each clamp has a quick spring force. When
reinstalling clamps, keep fingers clear.
Note: A mesh glass cover is available for this fireplace.
This cover is recommended to reduce the severity of burns
in case of accidental contact. Refer to the Accessories list
on Page 5.

BRIcK INStAllAtIoN

1. Remove glass door frame and log set.
. Remove the glass heat shield, baffle and rear
bracket.
3. Install the center firebrick panel on the back wall first.
Stand firebrick panel straight up against the back of fire-
place with the bottom edge at bottom of inner firebox.
4. Repeat Step 3 with the left and right side firebrick
panels. Secure the top of each side firebrick panel to
the fireplace with one retainer bracket and one screw.
5. Use a screw gun to drive in the self-drilling screw into the
sheet metal through the hole in the retainer bracket.
6. Re-install glass heat shield, baffle and rear bracket.
7. Re-install glass door frame and log set.
54D8001
Glass Frame
Figure 59 -
Remove Glass Frame
DVBH7 Series Direct Vent Gas Fireplace
Clamps
WARNING
!
FP2588
remove glass frame
AVERTISSEMENT
!
FP588
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
Un panneau vitré chaud peut
causer des brûlures.
Laissez refroidir le panneau
vitré avant d'y toucher.
Ne laisser jamais les enfants
toucher le panneau vitré.
41