Final Installation; Glass Frame Removal; Brick Installation; Eyebrow/Canopy Installation - Vermont Castings MLDV500NSCSB Installation & Operating Instructions Manual

Mldv direct vent gas fireplace
Table of Contents

Advertisement

MLDV Series Gas Fireplace
DANGER
A barrier designed to reduce the risk of burns from
the hot viewing glass is provided with this
appliance and shall be installed.

GLASS FRAME REMOVAL

NOTE: You must fi rst remove the safety barrier before you
remove the glass frame. To remove the barrier, simply lift up
and pull out until the tabs are clear of their corresponding
slots on the fi rebox. Then proceed to remove the glass
frame by following the steps below.
1. Remove access panel by lifting up and out.
2. Release three (3) clamps on bottom of fi replace. Figure
62
3. Tilt glass frame out and lift glass frame up until it clears
hook on top of fi replace.
4. Set glass frame aside.
CAUTION
Each clamp has a quick spring force. When
reinstalling clamps, keep fi ngers clear.
Glass
Frame
Clamps
Figure 62 -
Remove Glass Frame
44
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
Safety
Barrier
NOTE: A mesh glass cover is available for this fi replace.
This cover is recommended to reduce the severity of burns
in case of accidental contact. Refer to the Accessories list
on Page 57.

BRICK INSTALLATION

1. Install the rear brick panel by sliding it over the bracket
fastened to the rear of the fi rebox.
2. Remove the existing screws fastened to the sides of
the fi rebox toward the tops.
3. Slide the right panel into place and secure the panel
using one of the brackets provided with the kit and one
of the screws removed earlier.
4. Repeat step 2 for the left panel.

EYEBROW/CANOPY INSTALLATION

1. Remove glass frame.
2. Hold eyebrow/canopy with groove facing up and tabs
for screws facing down. Figure 63
3. Install by placing eyebrow under bottom lip of facing.
Hook bottom lip of facing into groove of eyebrow. Pull
eyebrow forward until it stops. Figure 63
4. Insert screws into tabs on bottom of eyebrow and into
holes in sides of facing.
Facing
Eyebrow/
Canopy
Groove
Eyebrow /
Canopy
Figure 63

FINAL INSTALLATION

Tabs for
Screw
FP2915
Tab
20306748

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mldv500pscsb

Table of Contents