Error Messages And Fault Correction - Brady BBP 72 User Manual

7 Fault Correction
50
7.3

Error Messages and Fault Correction

Error message
ADC malfunction
Barcode error
Barcode too big
Battery low
Buffer overfl ow
Card full
Cutter blocked
Cutter jammed
Device not conn.
File not found
Font not found
FPGA malfunction
Head error
Head open
Head too hot
Invalid setup
Memory overfl ow
Name exists
No DHCP server
No label found
No label size
No Link
No record found
Cause
Hardware error
Invalid barcode content, e.g. alphanumeric
characters in a numerical barcode
The barcode is too big for the allocated
area of the label
Battery of the PC card is fl at
The input buffer memory is full and the
computer is still transmitting data.
No more data can be stored on the memory
card
Cutter cannot return into its home position
and stays in an undefi ned position
No cutter function
The cutter is unable to cut the labels but is
able to return into its home position
Programming addresses a non-existent
device
Requested fi le is not on the card
Error with the selected download font
Hardware error
Hardware error
Printhead not locked
Printhead is overheated
Error in the confi guration memory
Current print job contains too much infor-
mation, e.g. selected font, large graphics
Duplicate usage of fi eld name in the direct
programming
The printer is confi gured for DHCP, but
there is no DHCP server, or the DHCP
server is not currently available.
The label format as set in the software does
not correspond with the real label format
Printer is loaded with continuous paper, but
the software is set on labels
The format size is not defi ned in the
programming.
No network link
Refers to the optional memory card;
database access error
Remedy
Switch the printer off and then on.
If error recurs call service.
Correct the barcode content.
Reduce the size of the barcode or move it.
Replace battery in the PC card.
Use data transmission via protocol
(preferably RTS/CTS).
Replace card.
Switch off the printer. Remove material.
Switch on the printer. Restart print job.
Change material
Switch the printer off and then on.
If error recurs call service.
Press the cancel key.
Change material.
Either connect this device or correct the
programming.
Check the contents of the card.
Cancel current print job, change font.
Switch the printer off and then on.
If error recurs call service.
Switch the printer off and then on.
If error recurs replace printhead.
Lock printhead.
After pausing the print job will be continued
automatically. If the fault recurs repeatedly,
reduce the heat level or the print speed via
software.
Re-confi gure printer.
If error recurs call service.
Cancel current print job.
Reduce amount of data to be printed.
Correct programming
Switch off DHCP in the confi guration, and
assign a fi xed IP address.
Please contact your network administrator.
Cancel current print job.
Change the label format set in the software.
Restart print job.
Cancel current print job.
Change the label format set in the software.
Restart the print job.
Check programming.
Check network cable and connector.
Please contact your network administrator.
Check programming and card contents.