Pilot Adjustment; Aeration Adjustment - Regency C34 Owners & Installation Manual

operating instructions
|
34

PILOT ADJUSTMENT

Periodically check the pilot flames. Correct flame
pattern has three strong blue flames: 1 flowing
around the thermopile, 1 around the thermocouple
and 1 flowing across the burner (it does not have
to be touching the burner).
Note: If you have an incorrect flame pattern,
contact your Regency
instructions.
Top View of pilot flame
Incorrect flame pattern will have small, prob-
ably yellow flames, not coming into proper
contact with the rear burner or thermopile
or thermocouple.
Top View of pilot flame
34 |
Regency CLASSIC C34-10 Direct Vent Freestanding Gas Stove
®

AERATION ADJUSTMENT

This adjustment is performed by the installer and
is primarily used in installations at high eleva-
tions. Push in for a yellow flame, or pull out for
a bluer flame. The burner aeration is factory set
but may need adjusting due to either the local
gas supply or altitude.
dealer for further
®
Caution: Carbon will be produced if air shut-
ter is closed too much.
Note: Aeration Adjustment should only be
performed by an authorized Regency
Installer at the time of installation or
service.
Natural Gas
Propane
®
5/16"
5/8"