Pedestal Assembly; Leg And Bottom Shield Assembly - Regency C34 Owners & Installation Manual

PEDESTAL ASSEMBLY

1. For easier assembly, tip the stove on its back (preferably onto a soft surface
to prevent scratching).
2. Unscrew the 4 bolts in the underside of the stove. Align the holes in the
corners of the pedestal top with the corresponding holes in the base of
the stove. Use washers which are supplied with the pedestal as shown
in diagram. Reinstall bolts.
3. Push the Regency logo into the two holes in the front bottom left corner
®
of the pedestal cover plate.
Note: Any paint touch up should be done
prior to placing logo on pedestal.

LEG AND BOTTOM SHIELD ASSEMBLY

These instructions apply to the steel leg and painted cast leg. It will be easier
to attach the legs to the stove if it is tipped on its back (preferably on a soft
surface to prevent scratching).
1. Remove the 4 bolts in the underside of the base and discard.
2. Slide the bolt and washer (supplied with the bottom shield) through the
leg, then slide the bottom shield in between the leg and the base of the
stove. Tighten the bolts.
3. Level the stove by adjusting the levelling
bolts in the bottom of each leg.
Anchoring Brackets Hold Down
Package Part# 846-585
Regency CLASSIC C34-10 Direct Vent Freestanding Gas Stove
®
installation
|
13
| 13