Heater Switch; Heating Element In Rear Handle - Stihl 034 Series User Manual

10.2

Heater Switch

– The front handle has to be
removed for access to the heater
switch - see 12.8.1.
Take the ground wire ring
terminal off the switch.
Pull the switch out of its seat.
Push back the rubber grommet a
little and pull the connector
sleeve out of the switch.
034, 036, 036 QS
Reassemble in the reverse
sequence.
Note:
Check correct installed position of
switch in its seat (switch seat in not
symmetrical).
10.3 Heating Element
in Rear Handle
– Remove the handle molding -
see 10.1
Slide the insulating tubes off the
two pin and socket connectors.
Separate the connectors.
Take the pressure pad out of the
handle recess.
– Release and remove the heating
element.
1
Important:
Make sure you install the heating
element that matches the
flywheel - see 6.4
1 = Previous heating element
2 = New heating element
2
51