4.5.2
Installing
Fit the lever (2) and spring (1).
Fit the E-clip (3).
Insert lever in the side of the hand
guard as shown.
Attach brake cable (1) to hole
(arrow) in brake lever (2).
14
1
1
2
3
Position the hand guard (1)
against the pivot pin and fit the
other side of the hand guard over
the fan housing.
Press the lever (1) slightly
downward and push the hand
guard and brake lever (2) onto
the pivot pins.
– Insert screw with captive washer
for hand guard and tighten down
firmly (see "Tightening Torques").
Important:
Coat all sliding and bearing points
with STIHL multipurpose grease,
see
13.2, or (better) with
molybdenum grease (e.g.
Molykote),
see
13.2.
Do not lubricate the brake band.
2
1
Attach spring (1) to the pivot pin.
2
2
1
First attach the brake band (2) to
the brake lever (3) and then push
it into the slot in the crankcase.
Install screw (1) with LOCTITE
243 and tighten down firmly (see
"Tightening Torques")
1
1
Hook the brake spring (1) to the
brake lever (2).
034, 036, 036 QS
3
2