Removing; Chain Brake (034, 036) - Stihl 034 Series User Manual

Unscrew the clutch clockwise
from the crankshaft (left-hand
thread).
On 036, 036 QS:
Remove cover washer from the
crankshaft stub.
– Disassemble and reassemble the
clutch - see "Standard Repairs,
Troubleshooting" handbook.
– Reassemble in the reverse
sequence.
Note:
Observe tightening torque for clutch
(see "Tightening Torques").
10
4.4

Chain Brake (034, 036)

4.4.1

Removing

Troubleshooting chart - see
"Standard Repairs, Trouble-
shooting" handbook.
– Remove the chain sprocket cover
and cutting attachment -
– Remove the clutch drum/chain
sprocket - see 4.1
2
1
Remove mounting screw (1) from
inner side plate (2) and lift side
plate away.
– Engage the chain brake by
pushing the hand guard away
from the front handle.
2
1
1
Remove mounting screws (1)
from cover (2) and lift the cover
away.
1
see 4.1.
Carefully pry the brake spring (1)
off the anchor pin and disconnect
it from the lever (2).
1
Ease the brake band (1) out of
its seat in the crankcase and
disconnect it from the lever (2).
1
Remove screw with captive
washer from the hand guard.
Note:
When installing, tighten down the
screw with captive washer firmly
(see "Tightening Torques").
2
2
034, 036, 036 QS