Sony HDVF-L750 Operation Manual page 7

q
(attention) indicator (amber)
Lights up when the camera detects certain conditions. The
conditions under which the indicator lights up are
specified on the camera.
For details on how to set up and verify the conditions
under which the indicator lights up, refer to the
operation manual of the camera in use.
r Mounting wedge
To attach the viewfinder to the camera, mount the
viewfinder in the V-wedge shoe attachment attached on
top of the camera.
For attachment, see "Attaching to the Camera" on page
8.
s Auxiliary indicator
Is not currently used.
t PEAKING control
Adjusts the sharpness of the viewfinder image.
Turn the control clockwise to make the edges sharper.
This control does not affect the output signal of the
camera.
u Lift-lock knob (HDVF-L770 only)
Turn this knob in the direction of the arrow indicated on
the knob to fix the height of the viewfinder.
v CAM connector (26-pin rectangular type)
Connect this to the VF connector on the camera using the
supplied connecting cable (26-pin).
w INPUT switch
Switches the input signal.
CAM: Inputs signals from the CAM connector.
SDI: Inputs signals from the SDI IN connector (monitor
mode).
x CAM connector (round-type, 20-pin)
Connects to the camera's VF connector using the
supplied connecting cable (20-pin).
CAUTION
When you connect the unit to peripheral device, use the
supplied cable to prevent malfunction due to radiation
noise.
Note
Use a round-type 20-pin connector when connecting to
the CA4000.
y SDI IN connector (BNC type)
When using monitor mode, connect this to the SDI OUT
connector on the camera or external device using a BNC
cable.
For details on supported formats, see "Specifications" on
page 26.
z DC IN connector
When power cannot be supplied via CAM connector,
connect to an external power supply (DC 10.5 V to 17.0
V). In this case, contact your Sony service representative.
wj COUNTER BALANCE control (HDVF-L770 only)
Adjust the counterbalance for the screen.
Turning the control toward + increases counterbalance. If
the control movement is too tight, lift the screen then turn
the control.
wk Up-tally lamp (red)
The supplied number plate can be attached to this.
The lamp lights up when the red tally signal is input.
wl Tilt friction adjustment knob (HDVF-L770 only)
Adjusts the friction in the tilting mechanism.
Turning the knob toward + increases the friction, and
toward – decreases the friction.
e; Cable clamp
Clamps the supplied connecting cable.
ea Lift friction adjustment knob (HDVF-L770 only)
Adjusts the friction in the lift mechanism.
Turning the knob toward + increases the friction, and
toward – decreases the friction.
es Lift fixing screw (HDVF-L750 only)
Adjusts the height of the viewfinder in two levels.
Functions of Parts and Controls
7