Connections And Copying - Sanyo HV-DX350A Instruction Manual

Connections and Copying

If you are using a RCA cable, select the AV input on the TV to see the picture from the player.
If you are not using a RCA cable, select the button number on the TV reserved for video input to see
the picture from the player.
To the TV via antenna cable (if you are not using a RCA cable)
If you are not using a RCA cable, your player can transmit pictures and sound to the TV via the coax aerial cable.
Just tune the TV to the player's transmitting channel (factory set to UHF CH36). Tune the TV carefully to ensure
the best pictures and sound.
Once you have carried out the steps in "Connecting up your player with RF
1
lead" , switch on your TV.
Press the [ENTER] button of the player's remote control longer than 5
seconds to call the player´s test picture.
Tune the TV to the test picture using the channel pre-set functions of your
TV as described in its manual.
When you have found the test picture, store it under the button number on
your TV for player input.
Press the [ENTER] button of the player's remote control again longer than 5
seconds to release the test picture.
• If the quality of the test picture transmitted to the TV is poor due to
2
interference caused by a station transmitting on channel 36, you can tune
the player to a different transmitting channel.
Find a free channel between 21 and 69 on your TV.
Call the player's "SETUP" choose "VCR SETUP" then "RF OUTPUT SET".
Type in the free channel.
Store and exit.
• If the quality of the test picture transmitted to the TV is poor, fine-tuning on the TV may help
(refer to the TV manual).
• Without a RCA cable, you will not get stereo sound from a TV capable of stereo sound.
RF OUTPUT SET
CH 36
0-9:SELECT (21-69)
OK:CONFIRM SETUP:END
35 35