Initial Installation - Sanyo HV-DX350A Instruction Manual

Initial Installation

Switch the TV on.
You can also start "AUTO SEARCH" in the SETUP "PR PRESET"
To tune in new stations (manual tuning) and to enter station names see page 27-28.
Setting up the player
CHECK IT!
• If you don't see the menu picture below after you press the menu button it may be because you don't
use a RCA cable and you need to tune the television to the player (see 'Connecting your player through
RF lead' on page 12). Normally a new player outputs a signal via the RF lead on transmission channel 36.
Search for the menu picture with the channel tuning function of your TV set (see its user manual). Some
televisions allow you to key in the transmission channel number in their tuning set-up menu.
• In case there will be interference problems with other transmission channels when the player outputs a
signal on transmission channel 36, the AUTO SEARCH process usually recommends an alternative, as in
step 4.
• There is a another way of setting RF output channel, if needed please see 'Connections and Assembling
on page 35'. It does not apply to models which do not generate the RF output signal.
1
Press on the remote control and RF36 will be displayed on the
front of your player.
Select a free channel on your TV and manual tune the channel
until the blue screen as shown in step 2 appears. Refer to the TV
manual for more details.
You should see this picture the first time you switch on the TV and
2
player.
Choose your language.
Then choose your country.
3
OK for "AUTO SEARCH!".
4
"AUTO SEARCH" tunes in all the stations you can receive in your
country.
18 18
"AUTO SEARCH".
LANGUAGE SET
ENGLISH
DEUTSCH
ITALIANO
ESPAÑOL
FRANÇAIS
NEDERLANDS
PR+/-:SELECT
OK:CONFIRM SETUP:END
COUNTRY SET
AUSTRALIA
NEW ZEALAND
PR+/-:SELECT
OK:CONFIRM SETUP:END
CH 25
PLEASE WAIT...
SETUP:END