Print Quality Check - Brother DCP-130C Quick Setup Manual

6

Print quality check

1
After the cleaning cycle is finished, the LCD
shows:
Set Paper and
q
Press Start
2
Make sure paper is loaded in the paper tray.
Press Colour Start.
The machine starts printing the Print Quality
Check Sheet (only during initial ink cartridge
installation).
3
Check the quality of the four colour blocks on
the sheet.
(black/ yellow/ cyan/ magenta)
Improper Setup
Avoid touching the printed surface of the paper
immediately after printing, the surface may not
be completely dry and may stain your fingers.
4
The LCD shows:
Is Quality OK?
q
a Yes b No
5
Do one of the following:
If all lines are clear and visible, press
a (Yes) to finish the quality check.
If you can see missing short lines, press
b (No) and go to step 6.
OK
6
7
8
Poor
Setting Up the Machine
The LCD asks you if the print quality is OK for
black and colour. Press a (Yes) or b (No).
Black OK?
q
a Yes b No
Color OK?
q
a Yes b No
After pressing a (Yes) or b (No) for both black
and colour, the LCD shows:
Start Cleaning?
q
a Yes b No
Press a (Yes), the machine will then start
cleaning the colours.
After cleaning is finished, press Colour Start.
The machine starts printing the Print Quality
Check Sheet again and goes back to step 3.
9