Table of Contents
Advertisement
Answering system
Answering system settings
5. Press q
or p
CID
•
Toll saver - the answering system answers a call after two rings if
you have new messages, and after four rings when there are no new
messages. This feature allows you to check for new messages and avoid
paying long distance charges when calling from out of your local area.
6. Press
/SELECT to save the setting. You hear a confirmation tone.
MENU
Press
CANCEL to cancel.
OFF/
NOTES:
•
If you subscribe to voicemail service through your telephone service provider, see Answering
system and voicemail indicators on page 60.
•
If you set the number of rings for the answering system as two or three rings, the caller ID
announce feature may not have enough time to announce the caller's full information.
Remote access code
To access your answering system remotely from any touch-
tone phone, you need to enter a two-digit number (00-99).
By default, the remote access code is 19.
To change the remote access code:
1. When the handset is in idle mode, press MENU/
enter the main menu.
2. Press q
or p
CID
press
/SELECT.
MENU
3. Press q
or p
CID
press
/SELECT.
MENU
4. Press q
or p
CID
/SELECT.
MENU
5. Use the dialing keys to enter a
/DELETE to backspace and delete a digit.
MUTE
/SELECT to save the setting. You hear a confirmation tone. Press
6. Press
MENU
CANCEL to cancel.
OFF/
to scroll and choose among 2, 3, 4, 5, 6 or Toll saver.
DIR
to scroll to >Answering sys, then
DIR
to scroll to >Ans sys setup, then
DIR
to scroll to >Remote code, then press
DIR
two-digit number. Use
SELECT
58
Play messages
>Answering sys
p
q
to
Answer ON/OFF
>Ans sys setup
p
q
REMOTE CODE
19
Advertisement
Table of Contents
