5-Point Calibration - Lowrance GlobalMap 5300C iGPS Operation Instructions Manual

11 Highlight
.
pear: Full Level Calibration Completed. Press
peatedly to get back to the main display.
Num Pts menu with 5-point calibration selected (left). Half level selected on
Fluid Level menu (center). Calibration Done window (right).

5-Point Calibration

5-point calibration is best suited tanks that vary greatly in shape from
top to bottom. You can begin calibration at any point in the 5-point cali-
bration process. We recommend starting calibration with an empty
tank. In a five-point calibration you will set five points: Empty Level, 1
Qtr Level, Half Level, 3 Qtr Level and Full Level.
In a 5-point calibration, you will have four calibration points left after
calibrating your tank's Empty Level. To figure out how much fuel you
should add for the remaining steps of the calibration process, divide the
total capacity of you tank by four. So, if you have a 40-gallon tank, each
quarter tank will equate to 10 gallons.
1. Press
MENU| MENU
2. Highlight
B
ration menu. A list of network devices will be at the top of the page. 3.
Select the desired EP-15 Fluid Level and press
4. Press ↓ to select
menu will appear.
5. Highlight
N
Make sure your tank is empty, then highlight
6.
. Select
ENT E
MPTY LEVEL
Select
7. C
ALIBRATE
Empty Level Calibration Completed. Press
Add 1 quarter tank of fuel, highlight
8.
1 Q L and press ENT.
TR EVEL
9. Select C
ALIBRATE
Qtr Level Calibration Completed. Press
and press
C
ALIBRATE
, use ↓ ↑ to select
and press
S
US ETUP
C
ALIBRATE
, press
P ENT
UM TS
and press
and press
and press ENT
. The following message will ap-
ENT
NMEA 2000
, which will open the Bus Configu-
ENT
and press
ENT
and select . Press
5
ENT.
. The following message will appear:
ENT
ENT
F
LUID
. The following message will appear: 1
ENT
145
, then press
ENT
and press
.
ENT
. The Device Calibration
.
ENT
F L
LUID EVEL
.
and press
L
EVEL
.
re-
EXIT
.
ENT
and press
. Select
ENT