5-Point Calibration - Lowrance LMS-520C Installation And Operation Instructions Manual

4. Press ↓ to select
menu will appear.
5. Highlight
N
Make sure your tank is empty, then highlight
6.
.
ENT Select E
MPTY LEVEL
Select
7. C
ALIBRATE
Empty Level Calibration Completed. Press
Add half a tank of fuel, highlight
8.
and press
H
ALF LEVEL
Select
9. C
ALIBRATE
Half Level Calibration Completed. Press
10. Fill up the tank, then highlight
and press
F
ULL LEVEL
Highlight
11.
pear: Full Level Calibration Completed. Press
peatedly to get back to the main display.
Num Pts menu with 5-point calibration selected (left). Half level selected on
Fluid Level menu (center). Calibration Done window (right).

5-Point Calibration

5-point calibration is best suited tanks that vary greatly in shape from
top to bottom. You can begin calibration at any point in the 5-point cali-
bration process. We recommend starting calibration with an empty
tank. In a five-point calibration you will set five points: Empty Level, 1
Qtr Level, Half Level, 3 Qtr Level and Full Level.
In a 5-point calibration, you will have four calibration points left after
calibrating your tank's Empty Level. To figure out how much fuel you
should add for the remaining steps of the calibration process, divide the
total capacity of you tank by four. So, if you have a 40-gallon tank, each
quarter tank will equate to 10 gallons.
C
ALIBRATE
, press
P ENT
UM TS
and press ENT.
and press ENT
ENT.
and press
ENT.
and press
C
ALIBRATE
and press
ENT
and select . Press
3
. The following message will appear:
ENTER
F L
LUID
. The following message will appear:
ENT
ENT
F L
LUID
. The following message will ap-
ENT
226
. The Device Calibration
.
ENT
F L
LUID EVEL
.
and press
EVEL
.
and press
EVEL
, then press
ENT
and press
. Select
ENT
. Select
ENT
re-
EXIT