Transfer Custom Maps And Gps Data Files - Lowrance GlobalMap 4000M Operation Instructions Manual

NOTE:
If you are already located at or near the end of your trail, the arri-
val alarm will go off as soon as you hit Enter. Just press
clear the alarm and proceed.
5. Now, begin moving and follow your GlobalMap 4000M.
6. When you reach your destination, be sure to cancel your navigation:
press |
MENU MENU
asks if you're sure; press ←|

Transfer Custom Maps and GPS Data Files

Custom Maps:
Custom maps work only from the MMC card or SDC card. When a card
containing a Custom Map File is loaded into the unit, it automatically
loads the map into memory when the unit is turned on.
Instructions for copying Custom Map Files to an MMC are contained in
the instruction manual for your MMC card reader and MapCreate 6
software. For instructions on inserting an MMC into the GlobalMap
4000M, see Sec. 2, Installation/Accessories.
NOTE:
To load a Navionics
GPS Data files:
GPS Data Files contain waypoints, routes, trails and event marker
icons. Instructions for copying GPS Data Files between your computer
and an MMC are contained in the instruction manual for your MMC
card reader and MapCreate 6 software.
GPS data automatically recorded in the unit's internal memory must be
saved to the MMC (as a GPS Data File) in order to store it on your per-
sonal computer. GPS Data Files stored on an MMC must be copied from
the card to the GlobalMap 4000M's internal memory before the unit can
read them. Here's how:
1. Insert the MMC into your unit. Press
| |↓ to
S ENT
ETUP
|↓ to
C
ANCEL
ENT

chart, see Sec. 5 for the entry Navionics Charts.
T M D
RANSFER Y ATA
|
N ENT
AVIGATION
.
MENU
| and the screen below appears.
ENT
49
. The GlobalMap 4000M
| |↓ to
MENU
to
EXIT
S
YSTEM